Look at any new boiler and you’ll see an energy label covered in letters, arrows and percentages. It’s meant to help you compare boilers, but most people we talk to aren’t sure what any of it actually means. The short version: nearly every gas boiler on sale now is A-rated, so the letter alone won’t separate them much. The size, the controls and how it’s set up in your home make the bigger difference to your bills. If you’re weighing up a new one, our boiler installations page covers how we pick the right boiler for homes across Bristol and Bath.

What does the energy label show?
Since September 2015, every new boiler sold in the UK has come with an ErP energy label. ErP stands for Energy-related Products, from the European rules the label was based on.
The label rates the boiler for heating on a scale from A+++ down to the lowest bands, with a coloured arrow showing where it sits. Combi boilers have a second rating for hot water. You’ll also see the boiler’s heat output in kW and how loud it is in decibels.
What does A-rated actually mean?
On the ErP label, an A rating for heating means the boiler has a seasonal efficiency of at least 90%. Seasonal efficiency is worked out over a typical year of use, not just in perfect lab conditions.
So for every £1 you spend on gas, roughly 90p or more ends up as heat in your home. The rest goes out of the flue.
Older boilers are a different story. A non-condensing boiler from the 90s might manage 70% or less, and some old back boilers are worse still.
The rules on efficiency
Two dates matter here.
Since 2005, new gas boilers in England and Wales have had to be condensing boilers. That’s what pushed efficiency up so sharply.
Then in April 2018, the Boiler Plus rules came in for England. Every new gas boiler has to have an ErP efficiency of at least 92%. It also has to be fitted with time and temperature controls. A new combi needs one extra energy-saving measure on top, such as weather compensation or a smart thermostat with automation and optimisation.
In practice, that means you won’t be offered an inefficient gas boiler any more. It’s one of the reasons the letter on the label isn’t a big deciding factor.
What about SEDBUK?
You might still see SEDBUK figures on older paperwork or comparison sites. It was the old UK system for rating boiler efficiency, with its own A to G letters.
The SEDBUK letter labels have been withdrawn so they don’t get confused with the ErP label. The SEDBUK percentage figures are still used in some energy calculations, like EPCs, but for comparing new boilers the ErP label is the one to look at.
Why condensing boilers are so efficient
A condensing boiler pulls extra heat out of its own exhaust gases. It cools them down until the water vapour in them turns back into liquid, and that releases heat that an old boiler would have sent straight out of the flue.
Here’s the catch. It only condenses properly when the water coming back from your radiators is cool enough. If the boiler is set to run very hot, it barely condenses at all and you lose a chunk of that efficiency.
That’s why we often suggest turning the flow temperature down. We explain how in what is boiler flow temperature and should you turn it down.
Does a higher rating mean lower bills?
Sometimes, but it’s not the whole story. Two A-rated boilers can perform quite differently in the same house.
What makes the real difference:
- getting the size right, because an oversized boiler cycles on and off and wastes gas
- good controls, so the house is only heated when it needs to be
- a sensible flow temperature, so the boiler actually condenses
- a clean system with a magnetic filter, so sludge doesn’t clog the heat exchanger
- an annual service, so it keeps burning cleanly
A well-installed mid-range boiler will often beat a top-of-the-range one that’s badly set up.
Upgrading an older boiler in Bristol and Bath
If your boiler is more than 15 years old, there’s a good chance it’s either non-condensing or an early condensing model that’s past its best. We still see plenty of both in homes around Bristol and Bath, along with the odd back boiler behind a gas fire.
Swapping one of those for a modern A-rated boiler is where you’ll notice the biggest drop in gas use. For an idea of prices, see how much does a new boiler cost.
Frequently asked questions
Are all new boilers A-rated?
New gas boilers fitted in England have to reach at least 92% ErP efficiency under the Boiler Plus rules, which puts them in the A band. So in practice, yes. What varies is how well each boiler suits your home and how it’s installed and set up.
Is it worth replacing a working boiler just for efficiency?
If it’s an old non-condensing boiler, the savings can be worth it on their own. If it’s a condensing boiler that’s working well, probably not yet. Reliability and repair costs usually decide it. Our guide on when to replace your boiler goes through the signs.
Does the energy label include my heating controls?
The boiler’s own label doesn’t. When a boiler is installed with controls, the installer can produce a package label that shows the combined rating, which can be higher than the boiler alone. Good controls are one of the cheapest ways to get more out of an efficient boiler.
Want a more efficient boiler?
Ring us on 01275 400 687 or get in touch online. We’ll look at your current setup and tell you honestly whether an upgrade makes sense.